+7 911 795 02 02
St. Petersburg
 

“Ritm” devices operation with RITM.LINK


RITM.LINK — is a free server software used to connect security equipment manufactured by “Ritm” to any type of monitoring software.
At the same time, RITM.LINK is a config and update tool for devices, based on web interface.

RITM.LINK key points:

  1. Remote setup via web interface
  2. Remote firmware update via web interface
  3. Device identification with IMEI
  4. Position locating via LBS
  5. Phone number identification of the SIM-card installed in device
  6. RITM.LINK integration into your own software via REST-API
  7. Data transmission to the monitoring software of different manufacturers via RITM.LINK

Remote setup
of the on-line units via web interface

RITM.LINK will help you to setup the devices that are connected to it. During the process RITM.LINK will use currently active GPRS-connection, so it doesn’t need connection with the device via CSD, though it’s still possible.

Remote firmware update
via web interface

You can update the built-in firmware of “Ritm” equipment via RITM.LINK, using currently active GPRS-connection without conncting to the device via CSD.

Device identification with IMEI

It’s obvious that you want to eliminate substitution of devices. RITM.LINK identifies the device with IMEI and transmits this data to the monitoring software.

Position locating via LBS

When identification of the device that sends the alarm signal to the monitoring software fails, you can locate it via cellular signal. When you’ll receive data from several base stations you’ll learn the location of the device that sends the alarm signal.

Phone number identification of the SIM-card installed in device

You can recall the phone number of the SIM-card installed in device via RITM.LINK in no time.

RITM.LINK integration into your software via REST-API

If you want to control the “Contact” devices using your own software, then open program interface REST-API will help you with that.

The program interface is open on purpose, so you could built-in interaction with RITM.LINK to your product. All the functions that are available for the user via web interface are also available to the software developers. Arming and disarming, equipment setup and firmware upgrade is available via REST-API. Third party software developers can operate this data.

Data transmission to the monitoring software of different manufacturers

Use RITM.LINK if you need to transmit data from our equipment with new firmware to the third party software. Data transmission to the following systems is guaranteed:

  • «Manitou»;
  • «Proxyma».



If you need to transmit data to some other third party software, please, address the “Ritm” Department of Customer Support.

In order to get free RITM.LINK software, please, address the “Ritm” Department of Customer Support.